Flue Liner Basics: What It Does and How to Know If Yours Is Failing
Published
Your furnace or boiler heats your home by burning fuel — gas, oil or wood. The heat goes into the air. The combustion gases go somewhere else. A flue liner is the pipe that carries those gases out of the house.
That distinction is the whole point. A chimney without a liner is an open flue: gases travel up the inside of the masonry, and any crack or hole in the masonry lets them into the rooms above. Carbon monoxide does not have an odor, and it does not announce itself. A working liner is the last barrier between your furnace and your living space.
Most homes built before the mid-twentieth century have no liner at all, though some builders lined them anyway. Most homes built after the 1990s have metal or ceramic liners. A retrofit liner installed into an existing masonry flue is also common.
Liners fail in predictable ways.
- Corrosion. Metal liners corrode from the inside out, especially in wood-burning appliances where creosote is acidic. Corroded sections can look fine from the firebox and be perforated higher up.
- Cracked clay. Clay liner sections crack, shift and fall. A shifted section blocks the flue.
- Separated joints. Sections pulled apart during a repair, or a chimney that shifted, leaves gaps the gases escape through.
- Wrong height. A liner that does not extend at least two feet above the roof surface — or above the flashing on a steep roof — allows rain into the chimney.
Relining is the standard repair when a liner is unserviceable. There are two broad approaches. A flexible reliner is a stainless or aluminum liner installed inside the existing masonry flue, with the top of the masonry chimney demolished down to the flue and a new crown built over it. A rigid reliner replaces the liner entirely with a new stainless steel or cast refractory pipe, usually with a new crown at the top. Rigid liners are more expensive and more durable; flexible liners cost less and suit most existing chimneys.
A note on fuel: never burn wood in a fireplace that has a stainless steel liner designed for gas. Wood burns hotter than the liner was rated for and will warp it.
If you are unsure whether your system has a liner, whether it is in good shape, or whether your appliance and liner are compatible, that is a short inspection and the cheapest hour you will spend on the system. Bring in someone who will check the whole run, not just the part you can see from the firebox.
Before using a wood-burning fireplace, work through the fireplace safety checklist as well as checking the liner.
- flue liner
- relining
- safety